|
| I just picked up a loader to mount on a John Deere 4255. The tractor has a stack for a third rear remote, shown below. Can one of these plugs on the stack can be used for the feed line going to the loader valve block?
I have another 4255 without the stack, and the plug circled in red is used for one of the loader valve lines. I’m assuming this is the return?
The Power Beyond fitting came with the loader, but if I don’t need it I see no reason to install it.
Edit: For some reason, the top of the first photo is cut off. There is a plug on top of the stack, and that is the plug I assumed would be used.
Edited by RancherInMT 10/1/2024 14:55
 (45EF09B9-8171-415C-AAD0-6A4C7C0CBF3E (full).jpeg)
 (C58BE2DB-E208-492A-8C7A-B95C444664FF (full).jpeg)
Attachments
----------------
 45EF09B9-8171-415C-AAD0-6A4C7C0CBF3E (full).jpeg (136KB - 3 downloads)
C58BE2DB-E208-492A-8C7A-B95C444664FF (full).jpeg (191KB - 1 downloads)
| |
|
Where to Plumb Mid Mount Loader Valve John Deere
