|
Netherlands | Thanks for your reply, but we use the older style RAVEN ready harness. In that time ter was no aux-function in the RSCM module, they added it later. I know this RAVEN style cable does not have all the pins connected, but we only use 3 sections so i will be able to rewire the P2(big) connector on the RSCM module to the correct pin ( if the wire isnt present) with the wire for section 12 e.g.
So the question is : which pin in the P2 connector has the aux-signal?
Thanks again.
Edited by PVM 5/10/2023 14:19
| |
|