|
North Dakota | The .39 Nudge increment is the default setting for the nudge. I usually set that to 1 inch. It is the setting for how much it moves the line every time you press the nudge button. Also set the minimum turn radius to 1/2 your implement width.
The setting you are looking for is on the implement page. If your roll cal is correct and the tractor, by itself, will drive back over it's original pass, you can add an offset to accommodate however much the implement drives offline. The direction that it has an overlap is the direction you set an offset. For example, if you have an overlap on the left side of 18 inches, you would set the overlap as -9 inches. The minus indicates a left direction. Get the implement centered on the pass then work with the width to get the coverage correct. You will have to get out of the cab and measure your offsets, don't try to guess from the cab. You will also need to make three passes after each adjustment to get the correct measurements. | |
|