AgTalk Home
AgTalk Home
Search Forums | Classifieds (206) | Skins | Language
You are logged in as a guest. ( logon | register )

Mercedes engine overhaul kit
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
kb ag
Posted 12/3/2022 22:34 (#9964044 - in reply to #9963854)
Subject: RE: Mercedes engine overhaul kit


nc ks
We had one that did that after we had it for a year and same symptoms as yours and we limped it through the end of harvest. We replaced the sensor in the intake, then we replaced the position sensor on the egr valve, then we replaced the throttle position sensor on the foot pedal. Check engine light still on and low power. One guy we talked to said even though we cleared the codes, sometimes it takes a little driving for the sensors to all play nice again. We took his advice and drove it around for 30 minutes instead of just around the section and back to the shop like we had been doing and it worked. Light went off and stayed off and good power since. Not sure which sensor it was, but don't remember them being that expensive. I would leave the footpedal until last, but just because it took longer to replace, may want to do it backwards from us though.

Edit. Ours is an 07 though. I think we also replaced the low water sensor on advice from agtalk.

Edited by kb ag 12/3/2022 22:38
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)