Near Intersection of I-35 & I-90 Southern Mn. | Yes, the Orange/white wire is connected to the output side of the Raven Master Switch. That means it can be used as a signal to another device to inform the other device that the 450 Master switch is ON (your situation) OR the Master switchon the 450 can be left OFF and another external switch or device can turn the Raven 450 ON to spray.
This second method is often used when it is more convenient to use an external switch rather than the built in Master. Some folks prefer a foot switch, some prefer a switch on a hydraulic lever etc. In these situations, the pure orange wire is often used as the 12V source since it is 12V whenever the 450 Power switch is ON. The "new" remote switch then goes between the pure orange and the orange/white wires.
In your case connecting the orange/white to the black wire on the Enviso can inform it that application is taking place so it will paint. Note that this would be "all or nothing" and partial passes where some sections are ON and others are OFF would not be painted 100% correctly. Even so this can be very helpful. It may be necessary to change some settings in the Enviso to inform it to "watch" the black wire. |
Connecting Envisio+ to Raven 450, the story continues.
