AgTalk Home
AgTalk Home
Search Forums | Classifieds (105) | Skins | Language
You are logged in as a guest. ( logon | register )

Ag Leader clutch module
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Kelly
Posted 5/11/2022 13:34 (#9656392)
Subject: Ag Leader clutch module


NC KS
I get the following messages on my InCommand monitor. I have a 16 row planter with 8 sections ran by Trimble air clutches. Planter worked fine before a rain delay. I put all new air lines on planter during rain delay and updated the InCommand to version 7.
It was giving me in the diagnostic section, an indication that 1 and 2 was working but not 3-8. Now, it doesn't show any switches working. I went through the connections except the ones inside the trimble trucount boxes. I didn't check the high current power that tees off of the multipin cable coming off of the module to the Trucounts.

Any ideas? Currently planting without clutches.
The other image is what the diagnostic tab gives me.
I checked the plugs going to the trimble trucount valve boxes. On the midule side, I have ground showing on 4 of the wires and 12 volt power on the power wire.

Edited by Kelly 5/11/2022 21:24




(16522940722511125258414298722957 (full).jpg)



(16523222500757081770116767334580 (full).jpg)



Attachments
----------------
Attachments 16522940722511125258414298722957 (full).jpg (84KB - 34 downloads)
Attachments 16523222500757081770116767334580 (full).jpg (63KB - 28 downloads)
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)