|
North Dakota | If it is consistent every round you can enter an offset in the planter setup, I'm pretty sure?? You can also put a button on a screen for TRIM or you can do a custom GPS position. All of these will correct your planter position.
Before you make any offset check your roll cal. With the implement out of the ground drive on a line in a flat area, stop on the line and mark a spot under the center of the drawbar, turn around and drive over the same line. When you reach the mark, stop and measure the distance you are off. If it is less than 1 inch you are probably OK. You can use a number of methods to set the roll cal but this seems to be the most accurate for me. | |
|