Near Intersection of I-35 & I-90 Southern Mn. | Sounds like a plan. Again you may only need to use the wire that is connected to the pin across from the notch. That wire must go to the signal wire out from the Trimble.
Remember to go into the menu on the Trimble and turn on the radar out (might be called digital out) to 57HZ. The 661 should be set to SP2 and try a speed cal of 612. If you get speed on the 661, then just tweak the speed cal on the 661 to get it to agree with the Trimble.
If that doesn't seem to work you may need to use the ground pin. Be careful with this step. Do not use the power out pin from the 661 (it will be 5V) as it is not necessary and may cause some other issues resulting in SMOKE. You don't want that. |