Posted 4/25/2022 11:05 (#9631158 - in reply to #9630474) Subject: RE: L oup Electronics Monitor on a JD 750 drill
north central kansas
I purchased a used Loup II system with 4 sensors on a 1560 drill. Got it all installed and went through the setup. You need a shaft sensor and then do the calibration of pulses per 400 ft. Loup has been really good about sending out manuals for legacy systems. I did learn that the sensors used on the Loup II are the same ones that will work for the new Elite monitor.
L oup Electronics Monitor on a JD 750 drill
