|
SW Georgia | Installed JD Autotrac 300 on a JD 8300.
Using GS2 1800 display and Starfire 3000 receiver.
Made it to step 2 of calibration process where it tells you to turn steering wheel to the right. During this step, it continues to say no steering wheel motion detected. After a few seconds of this, then we get an error message saying no flow meter magnet.
Flow meter is at least 2 feet away from any other electrical device such as the alternator, battery, isolator valve, and controller.
Not sure if we have a bad flow meter or connecting a hydraulic hose in the wrong connection?
Any advice would be helpful.
Edited by ESBROCK10 4/22/2022 19:08
| |
|