Posted 1/14/2022 22:00 (#9440628 - in reply to #9440610) Subject: RE: International 4000 windrower cab
I was thinking I almost had to, to do it right. If its not too bad I might just cut out a piece of sheet metal and weld it up, but I dont have high hopes. The problem I see myself running into if I end up doing that is the lack of access under the cab to grind, weld, and paint
If I did end up getting the cab loose and want to replace the floor how do I get the cab off? I really don.t have access to anything that can lift that high.
Any other general advice would be greatly appreciated, thanks