AgTalk Home
AgTalk Home
Search Forums | Classifieds (25) | Skins | Language
You are logged in as a guest. ( logon | register )

Raven Cr7 with UT unlock
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
JHEnt
Posted 10/4/2021 19:17 (#9252848 - in reply to #9252815)
Subject: RE: Raven Cr7 with UT unlock


Southern Illinois
Can you describe your equipment setup a bit more?

If it's a basic Accuboom node and you are going to keep your scs450 then you need some Raven display to make it work. An EnvisioPro could do the job.

I am not familiar with the most recent Raven modules so if someone is pricing one that is ISObus only then you likely would need a display with a VT.
(UT is a fancy name for a later compatibility VT but the name UT is not even part of the ISO published standard, it's some way manufacturers claims difference from early VTs that they never bothered to update to handle more data types)
The older EnvisioPro, Viper2, ViperPro did not have a VT programmed in.

So a simple old type Accuboom node worked on Raven CAN bus messages. Any older display will run one and can be setup to work with a 440-460 liquid rate controller.

If you are going to spend the money on a CR7 display and an Accuboom module, why not just add the product control as well and remove the scs450 from the system. This would make the system much smoother all around. You can also pickup older Raven product control and Accuboom with an older display used for pretty decent cost.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)