AgTalk Home
AgTalk Home
Search Forums | Classifieds (124) | Skins | Language
You are logged in as a guest. ( logon | register )

Remote engage switch xcn 750
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Josh7
Posted 6/4/2021 13:42 (#9041696 - in reply to #9041515)
Subject: RE: Remote engage switch xcn 750


The Netherlands
I assume you have a NAV 500 antenna , on the deutsch connector of that antenna pin 9 is external engage. There should be a momentary switch between
pin 10 and pin 9. Be careful because pin 10 is + 12Volt, don't make shortcuts with other wires.
If you follow the cables to harness 75742 you will find that same wires on the spare deutsch connector, but check that cable with a ohm meter if it are the same pin numbers.
From the foot switch you use only the 2 wires of the momentary switch, check with ohm meter. The third wire is ground.
If you are not sure about this or the wiring ask a Trimble technician.

I made my own wiring from a NAV 900, it has the same pin layout as a NAV 500 and connected it to a EZ pilot harness and that worked OK.

There is also a footswitch with a connector to the EZ steer controller, look on the AgToGo webside.

Edited by Josh7 6/6/2021 10:29




Attachments
----------------
Attachments NAV_500_Cabling_Guide.pdf (2784KB - 38 downloads)
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)