|
Kansas | Ok........here we go again but with snow everywhere what the hell.
1: Lets see the fact sheet to compare
2: That is a matter of opinion.
3: Again, lets see the fact sheet
4: If your not buying it, then why did you move up into a newer lower houred machine instead of just keep on repairing the 9600? If your going to tell me the technology, then why didn't you go try to find a machine with more than a couple thousand hours on it and save even more coin? I ain't buying your b.s. tonite about that. You know damn good and well as I do and everyone else on here.........less hours.........less likely problems. Which in turn creates better reliability, which creates better use of time which hopefully in the end will create more profit.
Now to continue on..........
Where did I address you? Is your name secretly jon?
We were comparing a 9760 against a 1680. Where in the hell did a cat engined agco machine come into play?
and if you would have gave 200 k for that machine, thats your baby but I'm with Jon on the ground that sort of money in todays unstable economy is just ludicrous.
You should put a blade on the feederhouse so you can at least push snow with it and start your ROI. *GRIN* | |
|
combine prices...
