|
| JDBrian is correct. Upgrade firmware on T2 controller by downloading from www.ez-steer.com. You will also need the correct cable to go from EZ-Guide 500 to EZ-Steer T2 box. The cable used for the EZ-Guide plus is not the same cable.
EZ-Guide 500 will come with cable that will have a 4 pin connector that is capped off. This will plug into the cable I am speaking of above that will then run to your T2 controller. You will have to purchase this separate from the EZ-Guide 500. | |
|
EZ Steer
