|
N.E. MT | A little off topic but I was curious if anyone has ever done a similar project to this but instead of using the hammers make it so you could put the kernel processor off your chopper on it. Like so it would make a massive roller mill. Set it up so you could take the kp off and put back on the chopper. Just curious if that would work. Also have a nearly new kp off our krone 1000 sitting in a shed. Would that work do you think? Reduce flouring, grind faster ect? Interesting project for sure I hope it goes well. | |
|
Project hammer mill-a tub no more
