|
Southern Minnesota | Have ISO 3660. Using integra as display and task controller.
The default factor in the VT settings screen for pneumatic down pressure to force is 4 correct? Manual says to leave at 4 unless told to change by Kinze personnel I believe. Mine came set at like 2200; when I try to adjust to 4 it won't let me type a number greater than 3.999. Four and over and the numbers are red and the check mark box not highlighted. What am I doing wrong?
Also, can't seem to get speed to show up in VT screen. Have tried automatic and GPS options in speed input settings. Manual says not all tractors and GPS receivers broadcast speed over the ISOBUS...I am using geo-steer with RTK. I get speed to show up when on agleader screens but not on the VT screens. What to do?
Thanks
Edited by SoMN 3/11/2016 22:18
| |
|
Kinze 3660? KMech & others
