|
Central Minnesota | Have you checked your lift switches? Should have 2 switches connected to a harness that goes to your rowflows main harness. You could try recalibrating them on your rowflow setup screen.
You could also go to your diagnostic page and under rowflow, there are 3 health checks you could run. One is "RFM Direction", it determines that the Rowflow module gyros are working. Next is "Motor Stability". This will run motors at 3 & 7 mph to check stability at different speeds. Last is " Voltage/Current" which will cycle power to the motors and clutches to check your wiring.
You can see if any of these checks have been done by pressing "previous health checks" on right side.
Hope any of this will help. | |
|