|
Mid-East Nebraska | IMPORTANT: Only one of the plugs that T in at the StarFire have RS232 wires. Make sure that the harness is connected properly to ensure the RS232 wires are coming from the receiver to the DB9.
Machines with bulkhead connector and new single connector SF3000 harness (PFP10469) will require PFP10470 adapter (shipped with new receivers) and adapter PF80722 available through parts.New SF3000.jpg
Machines with bulkhead connector and old double connector (PF80858) require harness PF80722: Figure 2.
Older machines with the harness and connector hanging from the roof: Figure 3.
Serial RS232 Output, the information on this page is the RS232 information. The following RS232 output settings can be configured on this page:
Serial Port Baud Rate 4800, 9600, 19200, 38400, 57600, 115200
Serial Port Output Rate 1, 5 Hz
Serial Port Message GGA on/off
Serial Port Message GSA on/off
Serial Port Message RMC on/off
Serial Port Message VTG on/off
Serial Port Message ZDA on/off
(GPS1.jpg)
Attachments ---------------- GPS1.jpg (91KB - 249 downloads)
| |
|