Near Intersection of I-35 & I-90 Southern Mn. | mit9750 - 6/16/2011 23:29
on the raven,, make sure baud rate is 9600,,trigger is one,,unit is seconds and data log is on
Yes, these are the proper settings on the Raven 440. If the Raven's memory has been cleared for some reason then these settings revert back to the defaults which are not correct for this applicaiton.
The quick and dirty test that I use with other equipment (not familiar with the 2600) to test the setup is to make a rate change on the third party device and watch the Rate 1 register on the 440. Sending a new rate from the third party device should cause the Raven to beep four times (unless the Rate change alarm is set to OFF) and this new rate should appear on the 440. If this happens then communication from the 2600 to the Raven is good.
Next turn ON the Master and some Boom switches on the 440. If the width shown on the 2600 changes in response to moving the switches then communication from the Raven back to the 2600 is good. When both of these tests work properly you should be good to go.
If either of these tests fail then there is still some setup or cable problem. |
JD 2600 and Raven 440 won't communicate
