|
ncia | I take off the barbed wire and roll that up first. (Have an old pto wire roller)
If there is woven wire onthe bottom half ,i leave it attached to the posts and go to each post with a tree puller or loader and chain, and pull it all up one post at a time. Usually the buried woven wire comes up with the posts but I have had to go along with pallet forks or skeleton bucket and dig it all out. Then I go along and pull staples and disconnect posts from woven wire,pick up the posts then roll the woven wire up by hand. If I start that with a very small center, I can roll up about 30 yards or so, cut that off and tie it up and then start another roll. I’ve taken out quite a lot of fence.
Edited by johnk 11/29/2025 06:12
| |
|
Best way to pull out fence?
