Boyden, Iowa Sioux County | I had to do this a few years ago.
Subject: Update an IMD-600 with a FMX Solution: IMD-600 Firmware Upgrade On FmX
1. Remove the WM Drain Plug-In and add the EZ Pilot Plug-In.
2. Power off the display.
3. Change the IMD 600 harness from port D to port A.
4. Power on the display.
5. The firmware should be built into v10.13, but if not then Load the IMD firmware into the Firmware folder on the root directory of the USB drive.
6. Upgrade.
7. Power off the display.
8. Change the IMD 600 harness from port A to port D.
9. Power on the display.
10. Remove EZ Pilot Plug-In and add back in the WM Drain Plug-In. |
Trimble upgrade IMU firmware
