|
NE, NE | it very well could be the wire going through the tube over the feeder house, there's a way to test if you have power going and returning from each side of the head. Make sure the wire harness that plugs into the head on the left side of the feeder house hasn't worn on that shield or feeder house belt. We had issues this fall where none of the settings were working and only had 11.7 volts on the power pin plugging into the head. We ended up finding a relay was weak in that fuse/relay panel right outside the door inside the grain tank. I believe it was the main engine power relay, but don't quote me on that | |
|
Dial a Matic diagnosis.
