|
| It looks like the unload is going to be too far from the unload. I have a bin that I bought used that I should have paid more attention to the builders on. The door was in the 3rd full ring with a half ring on the bottom. It was fine in my younger days but I have a terrible time getting in and out now. I just had a taller door installed lower but it is far enough from the unload that only the upper panels will open so I installed the auger port from an old butler bin in the lowest section of the door. Its probably big enough for an 8" auger . I plan on either using the vac or I have an old antique 4" auger that could be cut down to pull a couple bushels out and run it to the auger hopper. Just an idea.
Doesn't one of the panels have an auger port in the lindsay bin door already?
Edited by MN Dean 10/31/2025 08:43
| |
|
|
Grain bin. 21’ no intermediate sump, small door…idea?
