|
West Central Iowa | I had this 252 set up for IOWA CORS RTK and upgraded to a RTK 272 (before I really used it) and now would like to use it with an Insight for yield monitor/mapping. One of the concerns I have is that the Insight only shows a 1HZ output rate and I wonder if it should be at 5HZ, but the only options are 1HZ and ASAP. Also, the one screen shows ground speed sensor pulses, but does not show actual speed, is that because I have not done the distance calibration?
Here are a few shots of some of the screen if someone sees something that needs change please let me know. I have the cable and a laptop with the program to change the setup on the 252 and I updated the 252 firmware to V3.71 a little over a year ago.
Thanks!
(IMG_3104 (full).JPG)
(IMG_3105 (full).JPG)
(IMG_3119 (full).JPG)
(IMG_3123 (full).JPG)
(IMG_3094 (full).JPG)
(IMG_3096 (full).JPG)
(IMG_3098 (full).JPG)
Attachments ---------------- IMG_3104 (full).JPG (33KB - 116 downloads) IMG_3105 (full).JPG (38KB - 154 downloads) IMG_3119 (full).JPG (33KB - 129 downloads) IMG_3123 (full).JPG (31KB - 128 downloads) IMG_3094 (full).JPG (55KB - 147 downloads) IMG_3096 (full).JPG (43KB - 120 downloads) IMG_3098 (full).JPG (41KB - 130 downloads)
| |
|