|
| I have a 1790 24 row 20" planter getting tracks installed. Liq Fert was driven by piston pump. Don't think it will reach or work on the tracks.
Anyone with experience retrofitting a drive to run on tracks. Mine are made by Gramlow in ND. If that doesn't work, I need to go to hyd. I have all remotes in use, hyd drive 1, vac fans 2&3, lift & central fan 4, AgLeader downforce 5, Bauer hyd wing kit runs out of the back of the planter hyd bank. Where or how should I add hyd capacity/ability?
Planter is driven by AgLeader Integra monitor. Pulled by Challenger 765. I should drive it all by the monitor and split it to two sections. Very little time or expertise in this area. Suggestions appreciated. | |
|
Liq Fert Drive w tracks on 1790?
