|
West-Central Missouri | I have 2 Ez Guide 250's. with Ez Steer. I have had trouble with both of them freezing up this last week. They are in different tractors,and it happened in different fields.
1 system is about 10 yrs old, the other one was new this winter.
Both happened in similiar situations as follows:
I had just put a identical curve around a field end. First time was around about 60 ac. with a lot of trees curves. My signal went down a few times.
2nd time was around 3 sides of a 90 ac. field.
Both times were pulling sprayer, but with different tractors, and different Ez Guides.
So when I get done with Identical Curve I push "B" and the screen freezes up buttons do not work, screen does not blank out , just freezes at current image.
1st time I tried unplugging unit and restarting, it works fine until satelite on upper left corner turns green, then freezes up
Then Tried a soft reset,no luck,
Then Saved Tractor and Sprayer Configuration and Field on USB, did a hard reset, reloaded field and Config from USB .but as soon as I tried to load previous Identical Curve it froze.
Finally I created a new farm, new field. Then it worked
2nd Time it happened. I just started it creating a new AB line in same field so it would not load old one. That worked fine.
Has anyone had similiar experience?
Thanks ! | |
|