|
NW KS/ SC ID | Hey all,
Looking at a 22 footer (needs to be small enough for a L2/ L3 to lift and handle well), and was wondering what everyone with Shelbourne experience thought about the condition of the fingers and the drive belt on this header.
I stopped by Shelbourne's North American Headquarters (aka Colby KS, 30 miles east. :) ) and got a quote on new fingers, so I definitely want to make sure these are good. (didnt have pics or a link handy, otherwise I would have asked them about condition as well)
It is a Rice head, and the gentleman at Shelbourne informed me the fingers will need turned around to do wheat, in case anyone was concerned about them being installed backwards. :)
Any input appreciated,
Thanks!
Edited by GM Guy 2/10/2019 14:59
 (Shelbourne 2 (full).jpg)
 (Shelbourne 3 (full).jpg)
 (Shelbourne (full).jpg)
Attachments
----------------
 Shelbourne 2 (full).jpg (115KB - 132 downloads)
Shelbourne 3 (full).jpg (112KB - 124 downloads)
Shelbourne (full).jpg (107KB - 120 downloads)
| |
|
Shelbourne Finger Wear: Opinions needed
