|
Frytown, Iowa | My EZ Guide is not respecting my minimum flow settings. It just acts like I have nothing set for a minimum flow rate setting. It does however say minimum flow error on the screen WHEN the rate goes below my minimum flow rate so it does understand I don’t want it to go that low but for some reason it’s not communicating that message to my servo.
Is this a program problem, wiring problem, or a servo problem? The servo acts perfect for all other functions
(749ED352-E4D0-4D16-997A-4D9670F2989E (full).jpeg)
(56864D97-37A9-43F0-8110-E15B8828F89B (full).jpeg)
Attachments ---------------- 749ED352-E4D0-4D16-997A-4D9670F2989E (full).jpeg (92KB - 118 downloads) 56864D97-37A9-43F0-8110-E15B8828F89B (full).jpeg (170KB - 110 downloads)
| |
|