|
| Hi All -
Got a chance to run my new-to-me JD 9500 and Ag Leader Insight w/ yield monitor. Running into some issues. This is what I know:
- Insight powers up and connects to my GPS (using the Starfire 3000) just fine.
- Insight connects to all 3 modules per the system screen.
- Speed registers via GPS
- Both the Speed and Moisture modules are blinking green.
Here are my issues:
- Area won’t register at all, even though Speed and width are correct.
- I try the vibration calibration, and it says my elevator speed too slow. I click on the harvest system screen, and it shows a zero rpm.
- the red 5AMP fuse coming from the battery to the moisture module keeps blowingz
- The little auger on the elevator isn’t working.
Needless to say, my attempt to calibrate the system was a complete waste today.
Any knowledge is greatly appreciated.
(68700F38-6FFE-45EB-9799-574149444466.jpeg)
(F86ED5CA-CD14-4627-83EF-71D03301ED3C.jpeg)
Attachments ---------------- 68700F38-6FFE-45EB-9799-574149444466.jpeg (85KB - 464 downloads) F86ED5CA-CD14-4627-83EF-71D03301ED3C.jpeg (71KB - 460 downloads)
| |
|