I have an Insight controlling AgLeader SureStop clutches on my White 6100 planter. I have bought a 6900 splitter and am thinking about putting Trimble half-width clutches on it. I have gotten used to not stopping at each end to raise and lower planter. Can my InSight control both at the same time? What do I need to do this? Will I need another clutch control module? I know that all 23 rows will shut off at the same time so I will have a gap on some of the rows at the edge of headlands. If my InSight can't handle both, is it possible to split the signal from my EzGuide 500 to run an EzBoom and my InSight at the same time? Or 2 InSights? Thanks John |