|
NC KS | I get the following messages on my InCommand monitor. I have a 16 row planter with 8 sections ran by Trimble air clutches. Planter worked fine before a rain delay. I put all new air lines on planter during rain delay and updated the InCommand to version 7.
It was giving me in the diagnostic section, an indication that 1 and 2 was working but not 3-8. Now, it doesn't show any switches working. I went through the connections except the ones inside the trimble trucount boxes. I didn't check the high current power that tees off of the multipin cable coming off of the module to the Trucounts.
Any ideas? Currently planting without clutches.
The other image is what the diagnostic tab gives me.
I checked the plugs going to the trimble trucount valve boxes. On the midule side, I have ground showing on 4 of the wires and 12 volt power on the power wire.
Edited by Kelly 5/11/2022 21:24
(16522940722511125258414298722957 (full).jpg)
(16523222500757081770116767334580 (full).jpg)
Attachments ---------------- 16522940722511125258414298722957 (full).jpg (84KB - 263 downloads) 16523222500757081770116767334580 (full).jpg (63KB - 212 downloads)
| |
|