|
| Looking to add a foot switch to engage and disengage auto steer on a steer command running an Ontrac3. The steer command harness “remote” port is pinned as follows: pin 1 white, pin 2 red, pin 3 black, pin 4 green. I have a two wire foot switch and a 3 wire foot switch I can use, but neither have the correct deutsch connector to plug in, so I will have to modify the switch plug either way. Do I need 3 wires or can this be done with 2? How should it be pinned? Thanks!! | |
|
Steer command remote switch pin-out