Creating a RX map in JD ops or another program
gpsdude
Posted 3/11/2026 13:18 (#11581255 - in reply to #11580953)
Subject: RE: Creating a RX map in JD ops or another program


NE South Dakota Clark, SD
spudsco - 3/11/2026 09:49

gpsdude - 3/11/2026 08:35 You can do it very easily in GK Technology Inc Ag Data Mapping Solution. My first question is will your controller apply different rates on different nozzles, other than turn compensation?


Yes, the JD new software will let you do this now on a newer sprayer.   It will only apply different rates per boom section with a maximum of eleven sections.  I wish JD would allow more nozzles to boost instead of the six-maximum amount.



120 foot sprayer divided into 11 equal sections (more than likely not equal sized sections) = 10.9 ft or 3.3 meters. I am assuming rate will be based on the center location of each section. What are your section widths? ADMS could write this RX in a matter of a couple minutes per field once boundaries were loaded. Let me know if I can help.
Top of the page Bottom of the page