|
Crawfordsville, Arkansas | Got a few skid steer buckets around that have been ran without a bolt on cutting edge for too long. The actual bottom of the bucket where the cutting edge bolts on is worn down. Does anyone offer a replacement weld in piece for that? One of them is worn down at the bolt holes. Was able to patch up one on a CaseIh tractor enough to hold a new cutting edge but these skid steer buckets are about too far gone for a patch job.
These are Deere skid steers. 325 and a 326. Haven’t measured to see how wide but I’d say 5’ or so.
Did some looking around and didn’t find much other than replacement cutting edges online. Probably not searching the correct wording. | |
|
Loader bucket cutting edge repair??