farmer82 - 1/28/2026 18:48
I am hanging drywall and firring strips. Since I got my new Milwaukee impact driver in December I have a difficult time driving screws. It doesn't impact until I get the screw almost all the way in. This causes strip outs. My old Milwaukee driver i could hang drywall and just indent the paper all day long. It is too slow in the lowest setting and strips out in the higher settings causing a lot of verbage. I am using Montana bits from Menards I bought them because they are made in USA. Any suggestions?
Seems like you need a special drywall bit. | 
Impact driver bits and impact driver