|
NW Iowa | Here is the fieldstar diagram.
On mine i don't have my trimble hooked into the GTA.
It wasn't auto guide ready so i put on the platform kit.
Not sure exactly you would bridge your system into the fieldstar.
I thought there was a coax cable under the buddy seat that said GPS.
I'd have to go look to refresh
It might have been that junction in the upper right of the diagram
that says printer/ gps signal
Edit- If you globe is bridged into the system,
did you try just unplugging it up in the grain tank?
Edited by Massey1155 11/30/2025 13:23
 (KIMG20251130_130204564 (full).JPG)
 (KIMG20251130_130254525 (full).JPG)
Attachments
----------------
 KIMG20251130_130204564 (full).JPG (184KB - 3 downloads)
KIMG20251130_130254525 (full).JPG (173KB - 1 downloads)
| |
|