|
| We recently had a gfx750 installed in our massey 9795 combine for autosteer and sending gps signal to the c2100 for yield mapping in climate. To say the least our climate maps looked horrible. It showed us being in the middle of the neighbors field, going off in random directions and not capturing yield or moisture because of no signal on the c2100 (gfx never lost signal we run centerpoint). While I was cleaning the combine I noticed we never unplugged the Garmin receiver on the combine that came with it. Could it of been pulling gps from the Garmin instead of the nav900? If so other than unplugging the Garmin, how do I go about switching the c2100 from pulling from the Garmin so it will pull from the nav 900? The nav 900 is connected to the combine I just cannot find where to switch, where it is pulling gps signal from in the combine. Thanks in advance | |
|
Agco c2100 question