Jeffersonville, OH | JohnFarmer - 10/23/2025 17:21
Hi, I’m looking at a white planter 9800 series with isobus for row clutches. I don’t know a lot about isobus, exempt all I have is old tractor without computer in it.
I do have a isobus cci200 monitor that came with a baler I have. I also have a cfx 750 Trimble basic guidance system. What would be the most cost effective way to use isobus without getting too fancy.
The best would be to send gps signal to the cci200 and if its compatible with white planter I guess it would work?
Or just buy a new isobus monitor with gps capability?
Ok, so if you don't get the monitor with the Planter, you're gonna need Dickey John ISO Switch modules to make it work....HAVE to have them no matter what ISO Monitor you use.
Other than that, about any good ISO monitor will work.
I wouldn't say the CFX750 is a good ISO display though, getting kind of long in the tooth and might be a bit slow controlling that planter with clutches.
Not sure what a CCI200 is for the baler?
I have been around plenty of those planters...
Chris
Edited by c_mayer 10/23/2025 16:35
|
White isobus planter with non isobus tractor