Southern PA | CM84 - 9/9/2025 14:38
I did not see any until I pulled it out. I supposed seeing where they are now it is possible to see some of them while in the machine. I have always heard about them cracking and said its time to look into this. When i ran the machine at idle I could hear rubber squeaking and seen play in the rubber bushings. After taking the drive belt off and trying to roll it over by hand, noticed part off the revolution is harder than the other. After getting everything out I think the hard part of the revolution was the shaker frame hitting a weldment above the return or the clean grain cross auger on the right side of the machine
When you roll the shaker system over by hand, you'll feel spots that are harder to turn, and spots that are easier. Unless it's excessively hard/easy, that's normal as far as I know. |
9660 Chaffer Frame