Heil Harvesting, Ulysses KS/Limon CO | Sorry for the delay, hadn't had need to go to the machine shed in a couple days...
Here is what we did to adapt the heads to the Agco feeder houses. The height is just right. For the Axial machines, you do not have to cut any new holes for the top nubs, on the Gleaner you have to add a hole in the header for the left hump and put in fillers and flighting. You also have to cut holes on the bottom for the alignment nub. With all the holes in our feeder house I would think that you could about do anything for side to side adjustment you wanted to.
We are very happy with this setup, cost us about 3 hrs labor to get all the holes right (no drill press) and do the cutting plus iron.
.
|