|
| Had new yield /moisture module installed over the winter with combine in for winter special. Apparently didn't calibrate to pro600 . After finally finding error codes had me go into Toolbox and change type to VDMI.................
no help...................said next step is to send out tech to sit with a laptop for likely a few hours "diagnosing the problem"..................
Can anyone throw at me some extra steps that might work me thru it
.................Error codes indicate "line disconnected" but have checked all lines back on module on clean grain elevator etc.................
thanks for any input.
Edited by sbark 10/19/2016 22:35
| |
|
8010 yeld moisture
