Nebraska, The land of corn and cattle | It's the stock grate for an 02 R62, IICRC it's low wired from the factory.
If it's still got the factory feeder floor that will be your limiting factor right now. We haven't seen the need for the spacers all the way across yet, I know Hurtt has played with 1/2" on the thresher and 1/4" on the separator and had good results, but honestly, I hate to mess with ours as good as it works, might gain a little but not sure if it's worth the effort you know?
Outside of the longer shoe it's not much different than your 93. I'm sure youre needing it NOW but if you've got the time I know a few guys have been putting on 3 sweeps which you can do without any welding or removing the rotor. You just go through that removable cage section. I would order the kit of 6 and wait till the off-season and then pull the rotor and weld on the extra. |
Gleaner guys- separator grate adjustment/setup
