|
| The way I like to run the CDF rotor set up is like this: 1 reverse bar over main concave(1st section of bars), skip the second section, add 1 reverse to the 3rd section 180 deg. from the first, then 1 or 2 on the last section. I use the reverse bars to clean the concaves of cobs or leaves.
With the CDF don't be afraid to pull the sep. grate a little tighter than mid, pulled to the min. setting a few times depending on conditions.
If you add the spacers under the cyld. bars it will help a bunch.
Hope this helps. | |
|