|
| I did a survey with my kubota side by side with my FMX and the WM survey all worked out well. I had my plan made up using the Optisurface program and uploaded it into my FMX. The cut fill map came up on the screen and all looked good. But as I was working i realized the map is not centered in the correct spot. If you look at the picture the black dotted line is the center of two fields that i am leveling and the lowest spot in the field, as such i should have to fill in that spot not cut. the black line should be over to the right where the blue "fill" section of the map is. I realized now that i benched about 1 foot away from the master benchmark but the map is off by 15 or 20 feet. how do i bring the map over to the correct spot?
(20160726_193605.jpg)
Attachments ---------------- 20160726_193605.jpg (95KB - 132 downloads)
| |
|