| Dogface1SG - 7/22/2016 09:18
From the user's manual
The two connectors (Port A and Port B) can perform the following
functions:
• accept power
• accept TSIP, RTCM, ASCII, and (if enabled) CMR inputs
• output RTCM, TSIP, and NMEA messages
• output 1 PPS signals
Not sure about C, I would assume so though. You do have the radio TX to pin 8 of port B correct (Port 3, C in Ag Remote, RS232 Rx IN). I know you know your stuff but it is always that crazy infinitesimal detail that bights us in the butt.
What does it show for correction age? Nevermind, just looked at your pic in the initial post 1 second.
262 only does RTCM v2, not 3.0 for RTK like the 372 does |