|
NC Iowa | Finally finshed up rebuilding the striptill bar this week, so thought I would post some pictures of the rebuilt and upgrades we made to the units.
We built a stand in the shop to bolt the units to so that we could work on them inside and be able to work on them decently.
We replaced all of the bushings in the parallel linkage, all of the gauge wheel bearings, all of the trash wheel bearings because we put Sharktooth wheels on, all new coulter blades and most of the bearings in them. Then we fixed the catch disc pivots so we can get them off easily and put another grease zerk on the pivot so the don't freeze up. The we are trying to reduce the dirt build up on the catch discs by putting polly on them.
Any questions ask away.
(image.jpg)
(image.jpg)
(image.jpg)
(image.jpg)
(image.jpg)
(image.jpg)
(image.jpg)
Attachments ---------------- image.jpg (156KB - 118 downloads) image.jpg (188KB - 119 downloads) image.jpg (111KB - 96 downloads) image.jpg (127KB - 107 downloads) image.jpg (175KB - 107 downloads) image.jpg (165KB - 98 downloads) image.jpg (121KB - 95 downloads)
| |
|