|
Morris, IL | No need to look it up or anything right now, when i get around to maybe doing something i might contract you or agleader support. So those two pins i'm guessing are powered when fence rows are setup and turned on? The "teejet Chemsaver" (https://www.dultmeier.com/products/search/9421) have two pins, says when you energize it opens. Where do i have to ground that to, does it have to go back to DC to another pin or to the high current ground?
I think your spot on about putting them on switch 9/10, normally i turn what i need on and make sure all the others on off, if one is on in the end it won't stay for long as i'm always making sure what i'm not using is off from the old raven 440 days. I'll never have more then 8 sections on the sprayer.
Now on the boom sections could basically be setup the same way with the boom control port in DC? Thinking something like this. https://www.dultmeier.com/products/0.689.2204.3886/6242 I was thinking lot of those use 3 wires don't think. 12 volts, ground, and control? So in that case would i just hook the 12volt and ground to the high current power and then control would come off DC somewhere? Am i getting this mostly correct?
Thanks very much for your time Ted, always a big help to me and many others in this department.
Edited by NEILFarmer 5/29/2015 16:49
| |
|
JD 6500 sprayer section valves
