|
| Looking for ideas to hinge a gate to a steel pipe post. Post is galv so I'd rather not weld on it. I could go buy a 7/8" drill bit and drill a hole in it and use the regular gate hinge. Only other idea is get a collar to slide over pipe and run a 1/2" bolt through it to hold it in place and weld the hook end of the hinge on the collar. Any other ideas?
I'll add on some pics of my feeding floor project that I had pics of on here a few weeks back. finished putting up guardrail this morning. have a couple gates to hang yet and I'll be done. It's not much, but it's a start. Being only 26 I feel like I'm not keeping pace with my peers, but I'm content considering there was nothing here 5yrs ago where my facility is except a cornfield.
Edited by Jake_NEIA 5/27/2015 21:28
(20150525_160445.jpg)
(20150511_170734.jpg)
Attachments ---------------- 20150525_160445.jpg (133KB - 235 downloads) 20150511_170734.jpg (74KB - 228 downloads)
| |
|