|
all over the place | here is the best option for this application "imo", to run 20/20 seed sense and field view you will need to remove the factory seed sensors and replace them with precision planting harness and sensors, you will also add 2 precision vaccum sensors and a few weigh pins on the row units to see what your down pressure is doing, you will then have an ipad, 20/20 monitor and pro 700 in your cab, you can mount the 20/20 out of the way somewhere because you really wont need that for much "just bassicly a brain for the fieldview" so your pro 700 and ipad will be where your looking all the time.
accustat is junk in my opinion because it dosent actually map your singulation/down pressure ect..
I have installed the setup on many units and it works great! I would not use 20/20 rowflow to control the cnh planter just watching it with the 20/20 and fieldview will give you an enourmous roi because you will be able to make adjustments to your planter by viewing the ipad and its relatively cheap and easy to install compared to all the other options, if you have a dealer install it you will prolly end up with a price tag around 13-15k with parts and labor but I would not worry about paying someone, its fairly simple to do if you take your time and route the harness correctly. if done yourself should only cost around 10k
ps.. make sure and order 3 extra weigh pins with your kit, the 3 sent with the kit really don't give you enough down pressure info to go off | |
|
Case Monitor Options
